PLU45-500012 - PULSE LIPO 5000mAh 44.4V 45C STICK VERSION

PLU45-500012 - PULSE LIPO 5000mAh 44.4V 45C STICK VERSION

  • Category: Batteries
Availability: Out Stock
$274.99
Sold Out

Specifications:

  • Cell Count: 12S
  • Capacity: 5000mah
  • Discharge Rate: 45C
  • Charge Rate: 5C
  • Dimensions: 320mm x 50mm x 50mmí«ÌÎ_ (LxWxH)
  • Weight: 1360g
  • Balance Tap: JST-XH í«ÌÎ_

12S 44.4V Wiring:

Use a bullet style connector (male and female) to join the two (2) yellow wires - one male, and one female. This connector should be 5mm or larger, which allows the pack to be broken into two 6S packs for charging.

For the positive / negative (red & black) wires, these will solder to a standard connector of your choice, such as an EC5 connector. Once soldering is complete, the (2) yellow wires can be joined together, which will tie both packs into (1) 12S 44.4 battery, outputting 12S 44.4V power via the connector attached to the positive / negative (red & black) wires. This setup negates the need for a series connector, simplifying the wiring setup. You will need to make a custom charge lead for each 6S pack to allow each 6S battery to be charged independently.

Be extremely careful with polarity! Polarity reversals can cause serious damage to the battery, and can inflict serious harm - any such polarity reversals are NOT covered under warranty, and all such battery setups are the sole responsibility for the end user.


Alternative Wiring - (2) 6S 22.2V Setup:

Solder connectors of your choice (such as EC5Ì to (1) yellow wire, and (1) black wire, and solder another connector to the yellow & red wire. Be extremely careful with polarity! With this option, you will need to use a series connector to link both battery packs into a 12S 44.4V battery setup. However, charging is simplified, as each 6S pack is easily charged using standard charge leads and balance tabs.

 

Product Note:

Pulse batteries do not come with power leads, and will require the end user to solder their own style of battery connector for the battery to be properly used. Pulse batteries come with bare leads covered with heat shrink protection, and are ready for the connector of choice to be soldered to the positive/negative leads.